| HSPF-600C Automatic High Speed Pressure Former | |
|---|---|
| Forming area max | 580mm*780mm |
| Forming area min | 350mm*410mm |
| Tool width between material transport max/min | 800mm*380mm |
| Tool length operating dirscion max/min | 600mm*320mm |
| Materal width max | 830mm |
| Materal width min | 350mm |
| Spreading size per side max | 15mm |
| Material thickness (depending on material) max | 1.5mm |
| Material thickness (depending on material) min | 0.2mm |
| "Accuracy of material transport (Measured at the bridge of skeletal)" | 0.15mm |
| Index length max | 650mm |
| Index length min | 300mm |
| Forming part height above material level max | 125mm |
| Forming part height below material level max | 125mm |
| Table stroke up max | 170mm |
| Table stroke down max | 190mm |
| Stroke of blow box max | 160mm |
| Length of upper heater | 1800mm |
| Length of lower heater | 1800mm |
| Suction capacity of vacuum pump max | 200m³/h |
| Mould closing force max | 300KN |
| Forming pressure max | 6bar |
| Pressure air tank | 300litres |
| Operational pressure | 6bar |
| Number of cycles max | 30 1/min |
| Material level above ground | 1600mm |
| Total length inclusive material roll stand approx | 15000mm |
| Total width inclusive control cabinet approx | 4000mm |
| Height approx | 3400mm |
| Weight approx | 20000kg |
| Indivdual connected loads | |
|---|---|
| upper heater | 50kw |
| Lower heater | 50kw |
| Vacuum pump | 5kw |
| Table drives | 30/60/90kw |
| Material transport drive | 6kw |
| Total connected load (basic version) approx | 140/170/200kw |
| IPC-50/IDC-50 | |
|---|---|
| Punching table area max | 600*800mm |
| Part height (positive and negative) max | 125mm |
| Number of stroke | 30 1/min |
| Punching pressure | 50 ton |
